The details that need to be paid attention to in the daily work of the laser marking machine

Author: Correct Pack -Laser Marking Machine Manufacturer

If the laser marking machine breaks down during work, it may be dangerous, so novices who have not received professional training should not operate the equipment alone, so as not to cause accidents if they do not understand its structure, and the laser marking machine with a laser wavelength of 1064 In the case of work, there is a certain amount of damage to the skin of the human body. Therefore, the editor of Correct Pack summarizes the following details that need to be paid attention to in the daily work of these laser marking machines and laser cutting machines, hoping to be helpful to friends who are using laser equipment. ★ The operator must be trained to be familiar with the structure and performance of the equipment, and master the relevant knowledge of the operating system. ★ Comply with the general safety operation regulations of laser equipment.

Start the laser strictly according to the laser start-up procedure. Do not process a certain material before it is clear whether it can be irradiated or heated by laser, so as to avoid the potential danger of smoke and steam. You must wear protective glasses that meet the regulations. Put the fire extinguisher in a place that is easily accessible. When not processing, turn off the laser or shutter. Do not place paper, cloth or other flammable objects near the unprotected laser beam. Equipment When starting, the operator shall not leave the post without authorization or ask someone to wait for it. If it is really necessary to leave, it should stop or cut off the power switch. If any abnormality is found during the processing, it should be stopped immediately, and the fault should be eliminated in time or reported to the supervisor. When using gas cylinders , should avoid crushing the welding wires to avoid electric leakage accidents. The use and transportation of gas cylinders should comply with the supervision regulations of gas cylinders. It is forbidden to expose the gas cylinders to the sun or close to heat sources. When opening the cylinder valve, the operator must stand at the mouth of the cylinder. Side Keep the laser, the bed and the surrounding area clean, orderly, and free of oil, and the workpieces, plates, and waste materials are piled up according to regulations. When working, pay attention to the operation of the machine tool to prevent the cutting machine from going out of the effective travel range or two machines colliding to cause accidents . ★ After inputting the new workpiece program, test run it first, and check its running condition. ★ After starting up, start the machine tool manually at low speed in X and Y directions, and check whether there is any abnormality. ★ Observe high-voltage safety regulations during maintenance. Every 40 hours of operation or weekly maintenance, every 1000 hours of operation or every six months of maintenance must be carried out in accordance with regulations and procedures.