Introduction to the installation process of laser marking machine

Author: Correct Pack -Laser Marking Machine Manufacturer

For the fiber laser marking machine and fiber laser marking machine, he uses a laser marking machine made of fiber laser, which has good beam quality and a service life of 100,000 hours. If used properly, it will last longer. Compared with other types of laser marking, the electro-optical conversion efficiency exceeds 28%. Compared with other types of laser marking machines, the conversion efficiency of 2% to 10% has great advantages, and it is outstanding in terms of energy saving and environmental protection. For his own application, he is basically used in integrated circuit chips, computer accessories, industrial bearings, clocks and watches, electronic communication products, aerospace components, various auto parts, household appliances, hardware tools, molds, wires and cables, food packaging , jewelry, tobacco, military and other industries. The application range is wide and the coverage is expanding day by day. Let's talk about the installation instructions of the fiber laser marking machine: The first step, during the installation process, the main part to consider is the mechanical connection between the metal plate and the solid machined parts, machined parts, spring washers and washers, This adds two things. If necessary, it must be ensured that certain screws do not vibrate and loosen. This is equivalent to a process of laying the foundation. Only after all the installed screws are tightened can the subsequent process of installing the platform be carried out. The second part is the installation of electrical control devices. The main consideration is that the design of the control circuit should be reasonable. When the electrical component box should have some dust-proof functions, it should be noted that the device cannot start its own function when it is called again after a sudden power failure. The case is also fully connected to machine ground. During operation, due to the large vibration, it may have a certain impact on the circuit, and at the same time, there may be problems of short circuit or poor connection. However, there is no need to worry too much about these problems, and only the correct installation of the electronic control device can solve them. Finally, the main considerations for installation include the following parts: the red calibration must have a completely accurate optical path, the height of the optical axis at the module height must be the same as the focal point of the red light, and the oscillation chamber must be adjusted to twice the most suitable position. Of course, the red light hole should also be smaller. After the first half mirror is adjusted, the half mirror frame is locked and cannot be moved. It will only work properly if the desktop is fixed.