Automatic startup setting method of ultraviolet laser marking machine

Author: Correct Pack -Laser Marking Machine Manufacturer

Ultraviolet laser marking machine automatic boot setting method UV laser marking machine boot process and automatic boot setting method Automatic boot operation description The automatic boot mode is a control method applied to avoid complicated switching processes. Under current conditions, adjust the frequency and pulse width inside the UV laser marking software to determine the output power of the laser marking machine. Automatic start-up process: 1. First check the laser marking head and the control cabinet, open the dust-proof protective cover at the light outlet of the laser marking head to prevent the laser from hitting it and burn the lens, and check whether the window mirror is clean; 2. After turning on the laser Before marking the laser of the marking machine, ensure that the indoor temperature is between 15-30 degrees (air cooling) or check whether the chiller equipped with the laser marking machine is turned on (water cooling), and at the same time check the difference between the set temperature of the chiller and the actual temperature Less than 1 degree; 3. Turn on the main power switch button, normally closed to keep the laser in the energized state, if it has not been closed for a long time, it needs to be re-closed and preheated for about 2 minutes before turning on the key switch; 4. Turn on the key switch, UV laser marking The laser of the machine will enter the automatic power-on state after the inspection is completed; 5. During the process of the automatic power-on current rising, the automatic power-on program will preheat for 5 minutes at about 2/3 of the working current; 6. When the current rises to the working Current (about 7 minutes), you can open the ezcad software of the UV laser marking machine, and it can work normally according to the operation steps of the UV laser marking machine. 1111MicrosoftInternetExplorer402DocumentNotSpecified7.8 pt Normal0.